Data Recovery, inc.
(866) 432-8291
Raid Failure / Raid Data Recovery
HOME How-Raid-Works SHIPPING FORM | EXAMPLES | ABOUT

Raid Data Recovery:

Our Raid Engineers are highly qualified in the art of extracting data from a failed Raid Array. Emergency service is available 24/7 by calling 866-432-8291 (Toll Free) or direct for international callers +1 514-238-4090

 

Procedures: (the full service)

  1. Duplicate as many hard drives as possible.
  2. Determine the Raid failure and formulate a Data Recovery Strategy.
  3. If hard drive failures are detected, recover a mirror image of each failed hard drive.
  4. Determine the hard drive order and the stripe size of the Raid Array.
  5. Attempt to restore the raid adapter with the recovered hard drives.
  6. If the raid adapter cannot be restored, reconstruct the Raid image from the raw hard drives
  7. Return the Repaired Raid to the customer or provide the data on an appropriate destination media.
  8. For immediate assistance, fill out our SHIPPING FORM and contact us immediately (866) 432-8291

 

Raid Data Recovery Services: Raid Failure
Raid Servers can fail for a number of reasons:
  • On Raid 5 or Raid 10 server, at least two hard drive elements must fail to take the Raid Array OFFLINE.
    Most commonly, a first hard drive failure occurs at some point and is unnoticed, ignored or a replacement hard drive has been ordered but is not yet installed.
    A second hard drive (member Raid Element) develops a problem. Even a minor problem such as a few bad sectors can cause the Raid Array to crash
    Thus the reliability of a well maintained Raid 5 system is fairly good
    .
  • On a Raid 1 Array, just one hard drive malfunction can cause a crash.
    This is the worst of all Raid configuration. It has 2^N drives probability of failure, so that a 4 250GB hard drive Raid 0 has a 16X greater failure rate than a single 1TB hard drive. Most people don't even know they have a Raid 0 storage because it's in a sealed box, when they find out, it's too late.
  • Raid Controllers can fail.
    Raid controllers can also fail or lose their configuration settings. Power surges or power failures can cause problems especially if you don't have a UPS (uninterruptible power supply) or even if you have a UPS, if the battery runs out and you have no automatic shutdown procedure setup.
  • Other Hardware failure.
    Many other electronic parts in a server can fail but usually can be replaced without affecting the Raid Array. The worst minor defect that I have seen was a 25 cent molex drive power connector, 2 had failed intermittently eventually causing the Raid to crash.


Acknowledgements